CalderaSpas Moorea Manual do Proprietário descarregar pdf (Página 7)

DECK INSTALLATION

To be certain your deck can support your spa, you must know the deck’s maximum load capacity. Consult a qualified building

contractor or structural engineer. To find the weight of your spa, its contents and occupants, refer to the Spa Specification chart on

back cover. This weight per square foot must not exceed the structure’s rated capacity, or serious structural damage could result.

INDOOR/BASEMENT INSTALLATION

Be aware of some special requirements if you place your spa indoors. Water will accumulate around the spa, so flooring materials

must provide a good grip when wet. Proper drainage is essential to prevent a build-up of water around the spa. When building a new

room for the spa it is recommended that a floor drain be installed. The humidity will naturally increase with the spa indoors. Water may

get into woodwork and produce dry rot, mildew, or other problems. Check for airborne moisture’s effects on exposed wood, paper, etc.

in the room. To minimize these effects, it is best to provide plenty of ventilation to the spa area. An architect can help to determine if

more ventilation must be installed.

Caldera spas are equipped with a jet pump shroud to remove excessive heat from the equipment compartment. Find this vent and be

sure the vent is not blocked by anything, including carpeting.

Your Caldera dealer can help you with local information such as zoning regulations and building codes.

WARNING: Please keep the area around your spa well ventilated when it is installed indoors or in a confined area.

Inadequate ventilation around the spa could cause a build-up of a higher-than-normal concentration of spa chemicals and/or bacterial

fragments. These dispersed spa chemicals and/or bacterial fragments can be inhaled, and may result in breathing difficulties or lung

damage in certain people suffering from a compromised immune system or respiratory infection. If you or other bathers are affected

by this condition, please seek medical attention as soon as possible.

In addition to the above, properly clean and maintain your spa as follows:

Follow all procedures in this owner’s manual and printed instructions on all water care (chemical) products packaging.•

Test the water regularly to ensure proper levels of sanitizers, pH, and other water care requirements.•

Drain, clean, and refill your spa with fresh water on a regular schedule, and in accordance with this owner’s manual.•

Clean the filter(s) at least once per month.•

Check to make sure you have proper circulation throughout your spa water system.•

Have spa users bathe before entering the spa water.•

SPA LEVELING PREPARATION

Concrete sloped at 1/2 inch (1.3 cm) per 10 feet (305 cm) is preferred so that rain water and water spillover will run off and not puddle underneath the spa (water under

the spa for long periods of time may cause the wood to deteriorate). Other options are brick, stepping stone, or blocks.

It is important to note that soft surfaces, even when stepping stones are used to evenly distribute the weight of the spa, will have a tendency to settle, thus resulting in an

unleveled spa.

NOTE: Placing the spa on grass or dirt may increase the amount of debris which is inadvertently brought into the spa water and may cause harm to your equipment as

well as the spa surface, which is not covered under warranty.

SPA COVER INSTALLATION

Place the cover squarely on the spa.•

Position the tie-down locks included with your cover on the side of the spa so that they are easily reached •

by the cover tie-down straps. Allow for about 1/2” to 3/4” slack in the straps to make it easy to insert straps

into locks and to compensate for vinyl shrinkage in cold weather.

Attach the locks with the screws provided and insert the cover tie-down straps into the locks.•

NOTE: Keeping the cover in place any time the spa is not in use will reduce the amount of time the heater operates,

thereby minimizing operating costs.

INSTALLATION

Slope 1/2 inch per 10 ft. for proper drainage.

10 ft. (305 cm)

Stepping stones or brick may settle

causing the spa to be unlevel.

COVER INSTALLATION

TIE-DOWN STRAP

LOCK

COVER

KEY

SCREW (2)

DANGER. RISK OF INJURY.

• Neverleaveaspauncoveredorunattended.

• Neverleaveaspacoverunlocked.

• Donotstand,sit,orlieonthecover.

WARNING

Watkins Manufacturing

Corporation recommends

that the Caldera

spa be

installed above ground.

Lowering the top of the

spa to ground level, or

employing decking which

raises standing level

toward the top of the spa

substantially increases

the hazard of accidental

entry. Consult a licensed

building contractor to design

or evaluate your custom

decking requirements.

1/2 inch

(1.3 cm)

1 2 3 4 5 6 7 8 9 10 11 12 ... 43 44

Comentários a estes Manuais

Sem comentários

CalderaSpas Moorea Manual do Proprietário Página 7

Comentários a estes Manuais

Manuais e produtos relacionados com Piscinas acima do solo CalderaSpas Moorea